Expected load for tiling onto gypsum board should not exceed 32 kg m2.
Tiling on 1960 gypsum plaster wall.
If you have a tiling job to do in your bathroom and the walls have been skimmed with plaster you have to follow a few guidelines when installing tile to make sure you do not have a failure resulting in all the tiles coming off the wall.
Wall substrate maximum weight of tiling per m2 gypsum plaster 20kg m2 gypsum plasterboard direct without a plaster skim 32kg m2 plywood wbp up to 30kg m2 lightweight tilebacking boards up to 40kg m2.
Firstly check the condition of the plaster skim it should be fully dried out and a light.
Gypsum board is to be properly installed by the gypsum board installation contractor as described by the gypsum association s ga 216 which further references ga 214.
Dependant on the type and thickness of the board.
Dependant on the type and thickness of the board.
The lab report refers to grey plaster wherein it found 1 5 chrysotile asbestos.
A brown coat or rough coat of plaster.
Plaster walls became popular due to the durability and strength of the surface and are more common in historic homes that drywall.
Plaster is a material commonly used to create smooth wall surfaces suitable for receiving decorative finishes such as wallpaper paint and tiles.
When using a cement adhesive on your tiling projects you have to be careful when tiling direct onto neat plaster.
Lime plaster is the traditional finish for houses pre 1919 but may have been used up until the 1950s when plasterboard and gypsum took over.
Recommended thickness of the board is at least 12 5 mm.
A pinkish colour is likely to indicate a plaster bound with gypsum.
Notice that according to the lab report this plaster wall is comprised of the folowing layers.
Some preparation and a certain style of installation makes the process easier and more successful.
Glass reinforced cement sheets up to 50kg m2.
See our guide to lime plaster to find out more.
Make sure that gypsum board is strong enough make sure that gypsum board plaster board is strong enough to support the load from tiles and adhesive.
Gypsum plaster based products and cement products do not get on with each other and can cause de bonding this is due to the chemical reaction that goes on when the two come together.
The face layer joints of the gypsum board are to be treated with joint tape applied to a bedding coat of joint compound.