Tighten Lever Style Door Handle

These handles are available in a variety of styles and finishes to complement different decorating styles.

Tighten lever style door handle.

Kung fu maintenance shows door lock handle sagging has lost it s spring back qualities not bouncing back repair video get the new album up beat on itunes h. Hey if joe can fix a loose lever. Step 2 inspect the rod s surface and locate the groove where the set screw needs to be secured. This type is found commonly on lever style door handles.

To depress the detent use the end of a metal paper clip or the point of an awl inserting it into the hole and pressing the detent down while twisting and removing the door handle shaft off the spindle. Most homeowners will find that these devices are easy to remove if they are broken or damaged or if they simply want to replace it with a new style. Remove the screw and slip the lever handle off the rod. Make sure it s the trim ring you are removing and not the backing plate.

Determine whether you will need an allen wrench or a screwdriver based on the style of set screw which you will find on the bottom of the door lever. Tighten the screws or slotted bolts in the faceplate at the top and bottom of the handle on the front door. A lever door handle is used in place of a traditional doorknob on many modern locksets. Use an allen key to loosen the set screw on the side and remove the door handle use a flat head screwdriver to carefully remove the cover plate which will expose the two phillips screws take a phillips screwdriver to tighten the screw on each side this will secure the handle.

The detent is a spring activated pin concealed or small thin plate attached to the spindle that protrudes into a doorknob notch which prevents rotation. Keep the handle in place and replace the set screw on the bottom of the lever. Press down on the lever to reset the lock assembly. Tighten this with the screwdriver.

After the lever has been detached remove the decorative trim ring that covers the backing plate of the doorknob using a flat blade screw driver. Go slowly with this so you won t end up stripping the screw head. Now that the backing plate and screws are exposed tighten the long screws that run through the backing plate.